How to change the carbon brushes holder on a washing machine Hotpoint WMA60P

How to change the carbon brushes holder on a washing machine Hotpoint WMA60P
Safety FirstRemove the Plug from the Mains Socket
Tools required: T15 torx screwdriver & a 13mm spanner
Using the T15 torx remove the screws retaining the lower back panel
Lower back panel removed
Remove 2 screw cover caps on either side of the appliance
Using the T15 torx screwdriver remove 2 screws retaining the lid
Lift the lid a small amount
Push the lid backwards a small amount and remove it
Lid removed
From the top locate the drive belt at the rear of the appliance
Grip the drive belt at the same time rotate the drum pulley to remove the belt
Now remove the drive belt from the drive shaft
With the belt released from the drum pulley and drive shaft remove the belt
Using a soft cloth for protection lay the machine on its face (a folded dustsheet is useful)
Using a 13mm spanner remove 2 Motor retaining bolts
Using a 13mm spanner remove 2 Motor retaining bolts
With bolts removed now remove the motor from the drum casing
Make a note of the wires (a photograph is useful) and remove them
Wires removed
Motor removed
Locate the carbon brush holder on the Motor
Remove the single wire to the carbon brush
Wire removed
Using the phillips screwdriver remove 2 retaining screws on each holder
Remove the carbon brush holder
Carbon brush holder removed
Take the Carbon Brushes from its package ensuring its correct for the appliance
Locate the new carbon brush holder onto the motor
Using the phillips screwdriver fit the retaining screws securing the holder
Fit the single wire onto the new carbon brush
New carbon brush holder in place
Fit the wires to the motor
Locate the Motor into position on the drum housing
Locate the Motor retaining bolts
Using the 13mm spanner tighten both Motor retaining bolts do not over tighten
Stand the machine up and from the top feed the belt down past the drum pulley
Position the drive belt over the drive shaft
Position the drive belt over the drum pulley while rotating the drum pulley
The drive belt should be fitting centrally on the drum pulley
The drive belt should be fitting centrally on the drive shaft
Replace the lid
Using the T15 torx screwdriver replace 2 screws retaining the lid
Replace 2 screw cover caps on either side of the appliance
Using the T15 torx screwdriver replace the screws retaining the lower back panel

See full range of washing machine parts and carbon brushes here

Tools required can be purchased here

Disclaimer: The information provided has been prepared as a guide only and the steps taken are likely to vary for different appliance models. We strongly recommend using a qualified engineer to undertake major repairs and fault finding.