How to change a door handle on an oven. Indesit
-
How to change a door handle on an oven. Indesit
- Safety First:Remove the Plug from the Mains Socket
- Tools Required: A Phillips screwdriver
- Indesit (BIMS31KABIX)
- Open the door
- Locate the hinges on both sides
- Lift the hinge latch on both hinges
- Fold the latch over as far as it will go
- Fold the latch over as far as it will go on the other hinge
- Lift the door up to the hinge latch
- Lift the door further to remove it from the appliance
- Remove the door from the appliance
- Door removed
- Place the door on a protective surface,dustsheet, cardboard, etc
- Stand the door on its hinges and remove the door glass retaining screws
- Remove the door glass retaining screws
- Turn the door so the front door glass faces you
- Lift the front door glass out of the lower track of the oven door
- Turn the glass around and remove the door handle retaining screws
- Remove the door handle retaining screws
- Remove the handle from the glass
- Take the new door handle from its package ensuring its correct for the appliance
- Make sure the door handle bracket is in place
- Line up the door handle with the screws
- Replace and tighten the door handle retaining screws
- Tighten the door handle retaining screws do not over tighten
- Fit the front door glass into the lower track on the oven door
- Turn the door around
- Replace the door glass retaining screws
- Tighten the door glass retaining screws
- Tighten the door glass retaining screws do not overtighten
- Offer the door up to the appliance to locate the hinges
- Feed the hinges into the appliance on both sides
- Lower the door to its open position
- Lower the door to its open position
- Fold the latches back into the locked position on both sides
- Fold the latches back into the locked position on both sides
- Close the door the appliance is now ready for use
Disclaimer: The information provided has been prepared as a guide only and the steps taken are likely to vary for different appliance models. We strongly recommend using a qualified engineer to undertake major repairs and fault finding.
Comments