How to change the Heater Element on a washing machine Hotpoint WMA60P

How to change the Heater Element on a washing machine Hotpoint WMA60P
Safety FirstRemove the Plug from the Mains Socket
Tools required: T15 torx & flat head screwdriver a small hammer & a 10mm spanner
Smear a small amount of sealant around to areas where indicated
Using a soft cloth for protection lay the machine on its face (folded dustsheet is useful)
Using the T15 screwdriver remove the screws retaining the lower back panel
Lower back panel removed
Locate the heater element and make a note of the wires (a photograph is useful)
Remove the wires from the heater element
Using the 10mm spanner release the retaining nut do not remove the nut
Place the handle of the hammer onto the retaining nut and give it a sharp tap
Using a flat head screwdriver prise the heater and rubber gromet out of the drum
Remove the heater element from the drum
Heater element removed
Take the new heater element from its package ensuring its correct for appliance
Using a sealant to the surfaces of the grommet fit the new element into the drum
Gently tighten the retaining nut do not over tighten
Replace the wires
Using the T15 screwdriver replace the screws retaining the lower back panel
The machine can now be stood up

See full range of washing machine parts and heater elements here

Tools required can be purchased here

Sealant can be purchased here

Disclaimer: The information provided has been prepared as a guide only and the steps taken are likely to vary for different appliance models. We strongly recommend using a qualified engineer to undertake major repairs and fault finding.